SC-F2000 Revision C
ADJUSTMENT Overview 201
Confidential
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
Main Board
(NVRAM backup NG)
Before
replacement
1
Check the installed cartridges and the ink colors actually
charged.
---
√ ---
Replacement 2 Replace with a new one.
---
√√
p. 95
After
replacement
3 Remove all the ink cartridges. ---
√
---
4 Turn the power on in Firmware update mode.
---
√
---
5 Install the firmware.
√
√
--- p. 219
6
Check if “NVRAM Clear OK” is displayed on the control
panel.
---
√
---
7 Turn the power off. ---
√
---
8 Turn the power on in Serviceman mode.
---
√
---
9 Initialize the circuit board. (=> Turning the power off.)
√√
---
10 Turn the power on in Serviceman mode. ---
√
---
11 Head ID input
√√
--- p. 235
12 Turn the power on in Serviceman mode.
---
√
---
13 RTC input
√
√
--- p. 276
14 Serial number & USB ID input √
√
--- p. 275
15
Install ink cartridges (The cartridges with the same charged
colors confirmed in Step 1.)
---
√
---
16 Turn the power on in normal mode.
---
√ ---
17 Check version of the firmware.
---
√
---
18
Verify that the date/time settings are correct on the control
panel.
---
√
---
19 TF Motor measurement
√√
--- p. 282
20 IS Motor measurement
√√
--- p. 282
21 CR Motor measurement
√√
--- p. 282
22 Manual Uni-d adjustment
√
PGPP
√
--- p. 227
23 Manual Bi-d adjustment
√
PGPP
√
--- p. 229
24 TF Adjustment √ PGPP
√
--- p. 263
25 1st dot Position Adjustment
√
PGPP
√
--- p. 231
26 Make the replacement date & time setting.
√√
--- p. 277
Table 4-1. Adjustment Items and the Order by Repaired Part
Replaced or Repaired
(Reattached) Part/Unit
Required Operations
Service
Program
Jig Media Replaced Reattached Page
To Next Page
Loading...
