EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series Revision I
Disassembly And Assembly Disassembling the Printer Mechanism 99
8. Lift the Printer Mechanism grasping it by the holding positions with your hands,
and remove it from the Lower Housing.
When performing the following step, make sure to grasp the Printer
Mechanism by the specified positions shown below. Otherwise, the
frames may become deformed.
Figure 4-63. Handling the Printer Mechanism
Insert the Waste Ink Tube as shown in the figure below, and
secure it firmly with the Fastener. (refer to Figure 4-62 &
Figure 4-64)
Figure 4-64. Installing the Ink Tubes
Confirm that the PictBridge cable and the Waste Ink Tube do
not get caught in the Printer Mechanism.
0 Digit Side Ink Tube joint
130 Digit Side Ink Tube
0 Digit Side Waste Ink Tube
(Longer)
130 Digit Side Waste Ink Tube
(Shorter)
Install the Printer Mechanism to the Lower Housing as follows.
(refer to Figure 4-62)
1. Align the guide pins (x2) with the positioning holes as shown
below.
Figure 4-65. Reinstalling the Printer Mechanism
2. Place the
Printer Mechanism
on the Lower Housing and
secure the Shield Plate Holder and the Printer Mechanism
with the screw (A).
3. Verify the Printer Mechanism and Lower Housing are
tightly engaged (no rattling), and then secure the Shield Plate
Holder to the Lower Housing.
4. Secure the Printer Mechanism and Lower Housing with
screws (x5). (Tighten the screws in the order shown in Figure
4-62)
5. Secure the electrode cable to the Front Paper Guide with the
screw.
Right Rear
Left Rear
Positioning hole
and guide pin
Positioning hole
and guide pin
To Next Page
Loading...
Need help?
General
