105
10.4.5.1.2.3 Button
There is a button to proceed to the remaining settings based on the values entered on this page, and a button to go back to the
previous page.
Table 10-96 Button
<The case of product without LCD panel>
"If connection is lost unintentionally, initialize the network
settings on the product's control panel. And then configure it
again."
< The case of scanner with LCD panel >
"If connection is lost unintentionally, disable IPsec/IP Filtering
on the product's control panel. And then configure it again."
This message is shown on the bottom of the page.
This button is used to apply the entered values to the
system shown on the Confirm IEEE802.1X Settings page. If
pressed, Web Config goes to the Result page.
This button is used to go back to the IPsec Default Policy
Settings page.
To Next Page
Loading...
Need help?
General