Epson TM-P20II Reference Guide

116
10.4.6.1.1.3 Button
Table 10-115 Button
If Web Config recognizes an error in the entered value after the button is pressed, the following error pop-up is shown.
Table 10-116 Error Pop-up

"Password"
A text box is provided. The string must be from 1
to 128 bytes with characters in ASCII codes. (0x20
- 0x7E)
If "EAP Type" is "PEAP/MSCHAPv2" or "EAP-TTLS",
character must be entered.
- Not equipped with Wi-Fi chip
Can be entered by the user when "EAP
Type" is "PEAP/MSCHAPv2"
- Equipped with Wi-Fi chip
Can be entered by the user when "EAP
Type" is "PEAP/MSCHAPv2" or "EAP-TTLS"
"Confirm Password"
Same as Password.
Same as Password
"Server ID"
A text box is provided. The string must be from 0
to 128 bytes with characters in ASCII codes. (0x20
- 0x7E)
-
"Certificate Validation"
Two radio buttons are provided to choose one of
the following:
"Enable" / "Disable"
-
"Anonymous Name"
A text box is provided. The string must be from 0
to 128 bytes with characters in ASCII codes. (0x20
- 0x7E)
- When "EAP Type" is "PEAP-TLS" ,
"PEAP/MSCHAPv2" or "EAP-TTLS", user
can enter.
"Encryption Strength"
Select "Middle" / "High" by drop-down list.
-
Items
Description
Condition
"Next"
If pressed, Web Config goes to the Confirm
IEEE802.1X Settings page.
Only Wired LAN support products.
“Wi-Fi Setup”
If pressed, Web Config goes to the SSID Search
page.
Only products that support
WPA2/WPA3-Enterprise
Items
Description
"Invalid value below."
This message is shown when the value entered in the text box is invalid.
The item names of the corrected values are shown under the message in
the left cell. If there are two or more items whose values were corrected,
those items are listed line by line.
"Passwords you entered do not match."
When the password and the confirmation password do not match, this
message is shown.

Epson TM-P20II Specifications

General

Brand	Epson
Model	TM-P20II
Category	Printer
Language	English