Epson TM-P20II Reference Guide

120
10.4.6.1.4.3 Button
There is a button to proceed to the remaining settings based on the values entered on this page, and a button to go back to the
previous page.
Table 10-125 Button
10.4.6.1.5 Result Page
The following figure shows the page that is displayed after the network settings are processed.
10.4.6.1.5.1 Image
The content of the Result page will vary based on the result (success or failure).
Figure 10-55 Result Page
10.4.6.1.5.2 Setting Result
Table 10-126 Setting Result

<The case of product without LCD panel>
"If connection is lost unintentionally, initialize
the network settings on the product's control
panel. And then configure it again."
<The case of scanner with LCD panel>
"If connection is lost unintentionally, disable
IEEE802.1X on the product's control panel.
And then configure it again."
This message is shown at the bottom of the
page.
- Only from top page
Items
Description
"Apply"
This button is used to apply the entered values to the system shown on
the Confirm IEEE802.1X Settings page. If pressed, Web Config goes to
the Result page.
"Back"
This button is used to go back to the IEEE802.1X Top page in Basic
Settings or on the Wi-Fi Settings page.
Items
Description
"Shutting down."
"Restarting communication may take a few
minutes."
"If you want to change the settings, close the
Web Config and check your IP address. Then
enter your IP address in the browser to restart
the Web Config."
This message is shown when the settings are completed.
The network shuts down in order to update.
"Setup failed."
- This message is shown if the settings fail.
Setting Result

Epson TM-P20II Specifications

General

Brand	Epson
Model	TM-P20II
Category	Printer
Language	English