Epson TM-P20II Reference Guide

46
10.1.2.1.4 Button
Table 10-12 Button

"IPv6 Stateful Address "
Shows a valid stateful IPv6 address.
Shown if IPv6 is enabled.
Not shown when Connection Status
is disable.
"IPv6 Stateless Address 1"
Shows an IPv6 stateless address
Shown if the IPv6 Setting is used.
"IPv6 Stateless Address 2"
Shows an IPv6 stateless address
Shown if the IPv6 Setting is used.
"IPv6 Stateless Address 3"
Shows an IPv6 stateless address
Shown if the IPv6 Setting is used.
"IPv6 Primary DNS Server"
Shows an IPv6 address
Shown if the IPv6 Setting is used.
"IPv6 Secondary DNS
Server"
Shows an IPv6 address
Shown if the IPv6 Setting is used.
"Wi-Fi Setup"
"AOSS" / "WPS" / "Wi-Fi Direct" / " Manual" / "Wi-Fi Auto
Connect" / "Epson iPrint"
Shown if the wireless LAN is used.
"Wi-Fi Mode"
"IEEE802.11b" / "IEEE802.11g" / "IEEE802.11b/g" /
"IEEE802.11b/g/n"
Shown if the wireless LAN is used.
"The number of
connected devices"
Range of 0 to 4 in decimals
Shown if the Simple AP Mode is
enabled.
"SSID"
1~32 characters
Alphanumeric and sign characters
Shown if the wireless LAN is used.
"Channel"
Range of "1" - "13"
Shown if the wireless LAN is used.
"Security Level"
"None" / "WEP-64bit(40bit)" / "WEP-128bit(104bit)" /
"WPA-PSK(TKIP)" / "WPA2-PSK(AES)" /
"WPA2/WPA3-Enterprise" / "WPA3-SAE(AES)"
Shown if the wireless LAN is used.
"Password"
"Not Set" / "**********"
Shown if wireless LAN is used and
Security Level is not
WPA2-Enterprise.
"MAC Address"
"XX:XX:XX:XX:XX:XX"
X: Range of "0" - "F" in hexadecimal
-
Items
Description
"Refresh"
If pressed, updated information is shown on the top page.

Epson TM-P20II Specifications

General

Brand	Epson
Model	TM-P20II
Category	Printer
Language	English