Epson TM-P20II Reference Guide

98
10.4.5.1.1.2 Group Policy
10.4.5.1.1.2.1 Image
The following figure shows the layout of the Setting Items on the Group Policy page.
Figure 10-41 Group Policy of IPsec Basic Top Page
10.4.5.1.1.2.2 Setting Items of Group Policy
The following figure shows a layout of this settings area.
Table 10-92 Setting Items
Items
Description
Description
"Each policy is applied with
following priorities:"
"Group Policy 1 > Group
Policy 2 > ... > Group Policy
10 > Default Policy"
Description of the policy.
-
"Enable this Group Policy"
Enabled if the check box is selected
-
"Access Control"
- Use the drop-down list to make a choice.
"Permit Access" / "Refuse Access" / "IPsec"
- If "Enable this Group Policy" is
enabled, this item can be
configured.
<The case of products with
printing function >
"Local Address(Printer)"
<The case of scanner >
"Local Address (Scanner)"
-Use the drop-down list to make a choice.
"Unavailable" / "Any addresses"/ /IPv4 Address / IPv6
Address / IPv6 Link-Local Address / IPv6 Stateful Address/
IPv6 Stateless Address 1 / IPv6 Stateless Address 2 / IPv6
Stateless Address 3
IPv6Address, IPv6LinklocalAddress, IPv6StatelessAddress1,
IPv6StatelessAddress2, and IPv6StatelessAddress3 are
displayed when the address is set.
"Unavailable" is displayed when the Local Address and IP
Address for the printer are incorrect. "Unavailable" is not
set.
If the method for IP Address is auto, you can select "Use
automatically acquired IPv4 address (xxx.xxx.xxx.xxx)".
- If "Enable this Group Policy" is
enable, it is possible to set this
item.
Setting Items
Button

Epson TM-P20II Specifications

General

Brand	Epson
Model	TM-P20II
Category	Printer
Language	English