Epson WF-C5790 - Print Position Offset in Feed Direction

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a Revision A
Troubleshooting Troubleshooting procedure 143
Confidential
PRINT POSITION OFFSET IN FEED DIRECTION
 Symptom
The image is offset in the sub scanning (feed) direction (top and bottom
margins are not equal) and the top or bottom edge of the image is cut off.
Figure 4-8. Print Position Offset in Feed Direction
 Cause
 The paper that is being used is inappropriate.
 Paper settings of main unit or printer driver settings are inappropriate.
 Paper feeding failure
 PE Sensor Lever failure
 PE Sensor is dirty, failure, or has deteriorated.
 CR Unit (PW Sensor) is dirty or failure.
Sub scanning line (feed) direction
Main scanning line (CR operation) direction