Epson WF-C5790 - Page 506

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a Revision A
Disassembly/assembly Disassembly/Reassembly Procedures 506
Confidential
Ink Supply Tube
In the following steps, ink may spill from the Ink Supply Tube. Prepare waste cloths
or similar in advance.
1. Remove the two screws (S8: ), and remove the Ink Supply Tube from the Printhead.
Make sure the plate was attached.
A19
No. Screw Type
S8
C.B.EP-TITE SCREW,2.6X17(B=14),F/ZN-3C
Ink Supply Tube
Plate
Ink Supply Tube
2. Remove the Ink Supply Tube from the Tube Clamp.
At the marking point on the Ink Supply Tube, attach the Ink Supply Tube to the Tube
Clamp. If the marking is not visible, refer to the drawing above to attach the Ink
Supply Tube.
3. Remove the Tube Holder while pressing the hooks outward.
Ink Supply Tube
Tube Clamp
Tube Holder
Hook
Hook
87.5 ± 1 mm
Marking