Ericsson 86010158 - Safety Instructions; Explanation of Terms

Ericsson | Antenna Line Congurator
4
1 Safety Instructions
1�1 Explanation of terms
These instructions contain all the information necessary to install and operate the Antenna Line
Configurator (ALC)�
Keep these instructions for reference� If the unit is given to another owner, give them to the new
owner�
The target group of these instructions is experts, that is individuals who, for example:
• Are professionally trained as electricians, technicians, and so on
• Have knowledge of all the applicable terms and skills that are related to the installation and
operation of mobile communication systems
• Are familiar with the applicable national safety regulations
Risk of electric shock!
• Make sure that the mains cable (power supply cable) for the device (ALC) is not damaged�
Replace a damaged mains cable immediately�
• Do not use the device with a damaged mains cable�
• Use only the supplied power supply unit to supply the device with power�
• Connect the power supply unit only to the voltages specified on the type label/data sheet�
• Do no work on the installation in stormy conditions� In particular, do not connect cables and do
not disconnect cable connections�
• Make sure that the plug connection between the device and the installation can always be
accessed�
• There are voltages of up to 30 V at the device outputs�
• Be familiar with the methods of accident prevention required during the installation of
antennas�
See data supplied in the ALC memory� To show the data on a PC, connect the ALC to the PC
through a USB or Wi-Fi and export the data�
Risk of damage or destruction of devices!
• Read the ALC product documentation1) in full before you connect the system to the power
supply�
• Keep the ALC product documentation1) and give it to the next owner
Warning
Warning
Note
Note