Ericsson | Antenna Line Congurator
45
9�4�1 Change the FlexRET Settings
1� Tap ③ in Fig� 55 section 9�4 to show the FlexRET
properties� The following page is shown:
2� Tap ① in the previous figure� The following page is
shown:
① Opens the submenu to change the FlexRET properties�
① Opens the page to update the FlexRET firmware�
② Reconnects to the FlexRET�
③ Clears all alarms�
④ Calibrates all subunits, compare 3 section 9�4�1�1
⑤ Opens the submenu to change the protocol mode, see
section 9�3�2�1
⑥ Opens the page with the vendor-specific files�
Fig� 56: Devices: FlexRET properties Fig� 57: Devices: Changing FlexRET properties
To Next Page
Loading...
