Ericsson | Antenna Line Congurator
44
9�4 Operate the Ericsson FlexRET
Antennas with Ericsson FlexRET are factory-installed
with a Radio Frequency Identification (RFID) tag� The
tag contains key configuration data for the antenna� The
configuration details exported by the FlexRET and is read
by the ALC when scanning the AISG bus when connected to
a FlexRET�
Prerequisites:
• The ALC has found the ALD�
• The ALD is connected to the ALC, see section 9�1 and 9�2
① Opens the list with the individual subunits, see section
9�4�2
② Opens the FlexRET properties, see section 9�4�1
③ Generates ALD reports, see section 9�3
④ Selects the AISG protocol scanning options, see
section 9�1�1
① Shows the list of the individual subunits
② Opens the properties of the selected subunit, see
section 9�4�2
③ Opens the FlexRET properties, see section 9�4�1
④ Generates ALD reports, see section 9�3
⑤ Selects the AISG protocol scanning options, see
section 9�1�1
Fig� 54: Devices: Connected to a FlexRET Fig� 55: Devices: Configuring the individual
FlexRET subunits
1� Tap ① in Fig� 54 to open the list with the individual
subunits� The following page is shown:
To Next Page
Loading...
