Extron electronics DMP 128 Plus - Placing a Call with the Phone Dialer; Receiving a Call with the Phone Dialer

DMP 128 Plus • Configuration Tools 97
Placing a Call with the Phone Dialer
NOTE: VoIP lines must be registered with the call server via the DMP 128 Plus VoIP Web
page (see DMP 128 Plus VoIP Web Page on page167) and assigned to an Aux
input and output (see Aux Inputs on page43).
1. Select Tools>Phone Dialer. The Phone Dialer dialog opens.
2. Select a line using the Line buttons (see figure 163,
3
on the previous page).
3. Click New Call (
4
).
4. Enter the desired number or extension using the keypad (
7
). Alternatively, click the
number field (
6
) and type the desired number or extension using the keyboard.
5. Click the green “off hook” button on the keypad (
7
).
6. The appearance window (
2
) displays the status of the call.
7. Click Hold to place the call on hold. Click Hold again to return to the call.
8. Click the red “on hook” button to end the call.
Receiving a Call with the Phone Dialer
NOTE: VoIP lines must be registered with the call server via the DMP 128 Plus VoIP Web
page (see DMP 128 Plus VoIP Web Page on page167) and assigned to an Aux
input and output (see Aux Inputs on page43).
1. Select Tools>Phone Dialer. The Phone Dialer dialog opens.
2. When a call is incoming, the corresponding Line button flashes red.
3. Click the Line button with the incoming call.
4. Highlight the appearance the call is on.
5. Click the green “off hook” button on the keypad.
6. Click the red “on hook” button to end the call.