DMP 128 Plus • Configuration Tools 91
Date/Time
Using the navigation buttons ( ) is required to view the Date/Time tab, as it is located to
the right of the Serial Settings tab.
To set the date and time:
1. Click the Set Local button to sync the date and time information with the date and
time on the connected PC.
2. Set the time zone by using the Zone drop-down.
3. Use the Daylight Savings radio buttons to enter the daylight saving region, or leave
off (default).
-or-
1. Enter the desired date in the Date field. A drop-down calendar is available for date
selection.
2. Enter the desired time in the Time field by clicking on the hours and entering the hour,
then clicking on the minutes and entering the number of minutes.
3. Set the time zone by using the Zone drop-down.
4. Use the Daylight Savings radio buttons to enter the daylight saving region, or leave
off (default).
NOTE: The information displayed in the Date/Time tab is static. In order to update the
information to reflect the current time, click Refresh.
Figure 157. Date/Time Tab in Device Settings Dialog Box
figure 157. Date/Time Tab in Device Settings Dialog Box
To Next Page
Loading...
