Extron electronics DMP 128 Plus - Command and Response Table for DSP SIS Commands

DMP 128 Plus • Remote Control and Configuration 143
Command and Response Table for DSP SIS Commands
Command ASCII command
(host to device)
Response
(device to host)
Additional description
Audio level control and mix-point selection
NOTE: The command format is the same, regardless of the control being set. The acceptable adjustment range
varies depending on the control or mix point.
• The mic/line input gain range is -18 dB to +80 dB in 0.1 dB increments.
• The pre-mixer and virtual return gain range is -100 dB to +12 dB in 0.1 dB increments.
• The post-mixer gain range is -12 dB to +12 dB in 0.1 dB increments. Post mixer trim cannot be muted.
• The output gain range is -100 dB to 0 dB in 0.1 dB increments.
• All responses are shown with the DMP 128 in Verbose mode 2 or 3.
Set trim or gain
EGX7@*X7#AU} DsGX7@*X7#] Set gain on OID X7@ to a
value of X7# dB.
Example 1
(mic/line input 1):
EG40000*120 AU} DsG40000*120]
Set the mic/line input 1 to
a level of +12.0 dB.
Example 2
(pre-mixer gain 1):
EG40100*-8 AU} DsG40100*-8]
Set pre-mixer gain 1 to a
value of -0.8 dB.
Read trim or gain
EGX7@AU} DsGX7@*X7#] Gain on OID X7@ is set to a
value of X7# dB.
Example 1
(mic/line input 1) :
EG40000AU} DsG40000*550]
Mic/line input 1 gain is set
to a value of +55.0 dB.
Example 2
(post-mixer gain 1) :
EG60100AU} DsG60100*55]
Output 2, post mixer gain
is set to a value of +5.5 dB.
Audio Mute
Audio mute
EMX7@*1AU} DsMX7@*1] Mute audio at X7@.
Audio unmute
EMX7@*0AU} DsMX7@*0] Unmute audio at X7@.
Mute status
EMX7@ AU} DsMX7@*X7$]
Phantom Power
Enable phantom power
EZX7@*1AU} DsZX7@*1]
Phantom power is only
available on mic/line inputs
1 through 8.
Disable phantom power
EZX7@*0AU} DsZX7@*0]
Phantom power status
EZX7@AU} DsZX7@*X7$]
NOTES:
X7@
= Target OID See Object ID (OID) Number Tables on page150
X7#
= Level value: mic/line gain,
pre-mixer gain, virtual
return gain, post-mixer
trim, and output volume.
Levels use a 10x multiplier system with no decimal spaces. For
example, a level of +10.4 dB would be entered as 104 and a level
of -3.2 dB would be entered as -32.
X7$
= Mute/Phantom power
status
0 = disabled
1 = enabled