Extron electronics DMP 128 Plus - Input Processing; Input Gain Block

DMP 128 Plus • DSP Configurator Software 24
Input Processing
The mic/line input processing chain in DSP Configurator is visually represented by a string of
blocks(see figure 42 below). Each block contains a specific processor or type of processor.
For example, the Input Gain block contains a fader to boost or attenuate incoming signal,
the Filter block contains several types of filters, and so on. Inputs 1 - 8 contain the
following signal chain:
1. Input Gain Block
2. Input Filter Block
3. Input AEC Block (C Models Only)
4. Input Dynamics Blocks (2)
5. Input Delay Block
6. Input Ducking Block
7. Input Automix Block
8. Input Pre-Mixer Gain Block
Figure 42. Input Processing Chain for Inputs 1 - 8
Inputs 9 - 12 do not contain AEC processing or phantom power. All other processors are
available and function the same as inputs 1 - 8.
Figure 43. Input Processing Chain for Inputs 9 - 12
Input Gain Block
Double-click the Input Gain block to open the Input Gain dialog box.
Figure 44. Input Gain Block
figure 42. Input Processing Chain For Inputs 1 - 8
figure 43. Input Processing Chain for Inputs 9 - 12
figure 44. Input Gain Icon