Extron electronics DMP 128 Plus - Finding a Dante Device IP Address

DMP 128 Plus • Dante Controller 115
To rename a DMP 128 Plus AT transmitter:
1. Select Device View from the Device menu on the Network View screen or press
<Ctrl+D> on the keyboard. The Device View dialog box opens.
2. From the (Select a Dante Device...) drop-down menu, select the name of the
DMP 128 Plus AT (see figure 183,
1
below).
3. On the Device View screen, select the Transmit tab (
2
).
4. Click in the ChannelLabel column to the right of the name of the transmitter being
renamed. A text box and cursor appear (
3
).
5. Enter a new name (up to 31 characters) using any combination of letters, numbers, and
special characters except for @, =, and . (period).
6. Press <Enter> on the keyboard to confirm the name, or click another label text box.
7. Repeat steps 4 through 6 to rename additional transmitter channels.
8. When finished renaming transmitters, close the Device View dialog box.
Figure 183. Device View Screen — Renaming a Transmitter
Finding a Dante Device IP Address
To find the IP address of a Dante device, the name of the device is needed (see Renaming
the DMP 128 Plus AT in Dante Controller on page111).
NOTE: If the DMP 128 Plus AT has not been renamed, its default name consists of the
product name followed by a hyphen, plus the last 6 digits of the device MAC address
(for example, DMP128P-0ee8ee).
1. Open Dante Controller.
2. On the Dante Controller-Network View screen, click the Device Info tab (see
figure 184,
1
below).
3. On the Device Info page, locate the name of the DMP 128 Plus AT in the
Device Name column (
2
). The IP address is located in the Primary Address
column(
3
). In the example below, the IP address for the connected DMP 128 Plus AT
is 192.168.11.120.
Figure 184. Device Info Page
figure 183 Device View Screen — Renaming a Transmitter
figure 184 Device Info Page