DMP 128 Plus • Dante Controller 113
Renaming a Receiver or Transmitter
In addition to renaming devices, individual receiver and transmitter channels can be
renamed in Dante Controller. To better organize the various receivers and transmitters,
it is recommended each receiver and each transmitter be named using a description of
the device they belong to, the location of the device, or the purpose of the receiver or
transmitter.
To view the receiver or transmitter channels in Dante Controller, click the + sign next to the
receiver or transmitter device name to expand it. The + sign becomes a – sign when the
device is expanded (see figure 181,
1
below).
Figure 181. Expanded Device View — Input and Output Names
TIP: To simplify setup and operation of large matrix systems, rename the receiver and
transmitter channels to better indicate the source at the transmitters or receivers.
Renaming a Receiver
The default names shown in the Dante Receivers column are extracted from the Dante
interface of the connected device (see figure 181,
1
above). The DMP 128 Plus AT
receivers are labelled EXP_In-01 through EXP_In-48 because the DMP 128 Plus AT can
receive signal at the 48 EXP inputs. Follow the instructions on the next page to rename a
receiver.
figure 181 Expanded Device View — Input and Output
To Next Page
Loading...
