DMP 128 Plus • DSP Configurator Software 62
5
dBFS Text Readout — Displays a numerical readout of the output signal level.
6
Polarity Button — Click this button to invert the signal polarity of the selected output.
When the button displays the black + symbol on a gray field ( ), the polarity is normal.
When the button displays the black - symbol on a yellow field ( ), the polarity is
inverted.
7
Mute Button — Mutes the signal at the output stage.
8
OK Button — Confirms changes made to the contained parameters and closes the
Attenuation dialog box.
9
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the Attenuation dialog box was opened and
closes the dialog box.
Aux Outputs
Four Aux outputs (non-V models) or eight Aux outputs (V models only) are available in the
Aux Outputs panel. These outputs can be configured to route signal to a host computer as
USB audio via the rear panel USB audio port or to a VoIP network via a rear panel LAN port
(V models only).
Figure 107. Aux Outputs Panel
Naming an Aux Output
1. Click the Aux output name field.
Figure 108. Aux Output Name Field
2. Delete the text and type the desired Aux output name.
Figure 109. New Aux Output Name
3. Press the <Enter> key or navigate away from the field to confirm and apply the new
output name. Press the <Down Arrow> to navigate to and highlight the next name field.
Figure 110. Renamed Aux Output
NOTE: Follow the same procedure to edit an Aux output name.
figure 107. Aux Outputs Panel
figure 108. Aux Output Name Field
figure 109. New Aux Output Name
figure 110. Renamed Aux Output
To Next Page
Loading...
