DMP 128 Plus • DSP Configurator Software 17
Macros Drop-Down
The Run Macro drop-down list is available when connected to the DMP 128 Plus in Live
mode. The drop-down list is unavailable in Emulate mode.
The Run Macro drop-down list allows the user to view and run all macros that have been
pushed to the device. The list of macros updates dynamically when a new macro is created.
Macros created in DSP Configurator that have not been pushed to the device appear in the
list with an asterisk to the right of the macro name. Only macros that have been pushed to
the device can be run from the Run Macro drop-down list (see Macros on page78 for
information on configuring macros).
Figure 22. Macros Drop-Down Menu
Presets Drop-Down
The Presets drop-down menu allows the user to view and apply presets saved in the
current configuration file or on a device connected in Live mode. Presets with an asterisk
next to them are on the DMP 128 Plus, but not in the current configuration file. Run a preset
to load it into the configuration file. Alternatively, perform a backup to run all presets and
load them into the current configuration file (see File on page13).
Figure 23. Presets Drop-Down Menu
After selecting a preset from the list, choose one of the following actions from the
DSPConfigurator status panel:
Recall — Recalls the selected preset and applies settings to the main workspace.
Cancel — Cancels the preset recall and returns to the main workspace with the current
emulation or state intact.
Delete — Deletes the selected preset from the configuration.
Figure 24. Preset and Action Selection
DSP Configurator Status Panel
This panel displays the current status of DSP Configurator and shows when data is being
pushed to or pulled from the device. When the software is ready to perform actions, the
panel reads Ready.
Figure 25. DSP Configurator Status Panel
figure 22. Macros Drop-down Menu
figure 23. Presets Drop Down Menu
figure 24. Preset and Action Selection
figure 25. DSP Configurator Status Panel
To Next Page
Loading...
