Extron electronics DMP 128 Plus - Renaming a Virtual Return; Virtual Return Building Blocks; Virtual Return Processing

DMP 128 Plus • DSP Configurator Software 48
Renaming a Virtual Return
1. Click the virtual return name field.
Figure 81. Virtual Return Name Field
2. Delete or highlight the text and type the desired name.
Figure 82. New Virtual Return Name
3. Press the <Enter> key or navigate away from the field to confirm and apply the new
name. Press the <Down Arrow> key to navigate to and highlight the next name field.
Figure 83. Renamed Virtual Return
NOTE: Follow the same procedure to edit a Virtual Return name.
Virtual Return Building Blocks
Building blocks can be applied to all 16 virtual return channels (see Input Building Blocks
on page22 for more information on configuring virtual return building blocks).
Virtual Return Processing
Virtual returns A through D contain the following signal processing chain:
1. Virtual Return Feedback Suppressor Block
2. Virtual Return Filter Block
3. Virtual Return Dynamics Block
4. Virtual Return Delay Block
5. Virtual Return Pre-Mixer Gain Block
Virtual returns E through P contain the following signal processing chain:
1. Virtual Return Filter Block
2. Virtual Return Dynamics Block
3. Virtual Return Delay Block
4. Virtual Return Pre-Mixer Gain Block
NOTE: Only Virtual Return channels A through D contain Feedback Suppression
processing blocks.
figure 81. Virtual Return Name Field
figure 82. New Virtual Return Name
figure 83. Renamed Virtual Return