Extron electronics DMP 128 Plus - Configuring Digital I;O

DMP 128 Plus • Configuration Tools 73
Configuring Digital I/O
1. In the Digital In panel, select an action from the Action drop-down.
Figure 130. Selecting Digital In Action
2. From the Acting upon drop-down, select the input, group, preset, or macro affected
by the action.
Figure 131. Selecting Digital In Acting Upon
3. From the Digital Out 1 panel, select a mode for the digital output from the Mode
drop-down.
Figure 132. Selecting Digital Out 1 Mode
figure 130. Selecting Digital In Action
figure 131. Selecting Digital In Acting Upon
figure 132. Selecting Digital Out 1 Mode