Extron electronics DMP 128 Plus - Output Delay Block; Output Filter Block; Output Dynamics Block; Output Attenuation Block

DMP 128 Plus • DSP Configurator Software 61
Output Delay Block
One delay block is available for each output channel. This block functions the same as
the mic/line input delay block (see Input Delay Block on page37 for information on
configuring the output delay block).
Output Filter Block
One filter block is available for each output channel. This filter block functions the same as
the mic/line input filter block, except that there are 10 slots for filters instead of 5 (see Input
Filter Block on page26 for information on configuring output filters).
Output Dynamics Block
One dynamics block is available for each output channel. This block functions the same
as the mic/line input dynamics block (see Input Dynamics Blocks on page32 for
information on configuring the output dynamics block).
Output Attenuation Block
Double-click the output Attenuation block to open the Attenuation dialog box.
Figure 105. Output Attenuation Block
The Attenuation dialog box provides attenuation control for the selected output.
Figure 106. Attenuation Dialog Box
1
Output Name — This name changes to match the default or user defined output name.
2
Output Attenuation Fader — Click and drag the trim fader to provide up to 100dB
of attenuation. Click the trim fader and use the <Up Arrow> or <Down Arrow> to adjust
the fader up or down in 1 dB steps.
3
Output Attenuation Text Box — Allows the user to enter a gain or attenuation value in
0.1 dB steps.
4
dBFS Meter — Provides post-attenuation and pre-mute a readout of the output signal
level.
figure 105. Output Attenuation Block
figure 106. Output Attenuation Dialog Box
1
Output Name
6
Polarity Button
2
Output Attenuation Fader
7
Mute Button
3
Output Attenuation Text Box
8
OK Button
4
dBFS Meter
9
Cancel Button
5
dBFS Text Readout