Extron electronics DMP 128 Plus - Outputs; Naming an Output

DMP 128 Plus • DSP Configurator Software 58
Outputs
Eight outputs are available in the Outputs panel and route signal to the eight rear panel line
level analog outputs. Signal routed to these outputs can also be transmitted onto the Dante
network on DMP 128 Plus AT models.
Figure 95. Outputs Panel
Naming an Output
1. Click the output name field.
Figure 96. Output Name Field
2. Delete the text and type the desired output name.
Figure 97. New Output Name
3. Press the <Enter> key or navigate away from the field to confirm and apply the new
output name. Press the <Down Arrow> key to navigate to and highlight the next name
field.
Figure 98. Renamed Output
NOTE: Follow the same procedure to edit an Output name.
figure 95. Outputs Panel
figure 96. Output Name Field
figure 97. New Output Name
figure 98. Renamed Output