DMP 128 Plus • Dante Controller 111
Renaming the DMP 128 Plus AT in Dante Controller
NOTE: Dante device naming can also be done via DSP Configurator (see Dante Device
on page92).
1. Ensure that the control computer and a single DMP 128 Plus AT are connected to the
same network.
2. From the control computer Start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
3. The Dante Controller - Network View screen opens. All Dante devices on the
network are discovered and listed.
4. From the Device menu, select Device View or press <Ctrl+D> on the keyboard (see
figure 176 below).
Figure 176. Opening Device View
5. The Dante Controller - Device View dialog opens. Select the device being
configured from the (Select a Dante Device...) drop-down list (see figure 177,
1
below).
Figure 177. Device View and Select a Dante Device Drop-Down
NOTES:
• If there are multiple DMP 128 Plus devices connected to the network that
have not been renamed, obtain the Dante interface media access code (MAC)
address of the desired device from the white label on the rear panel of the
device in order to identify it in Dante Controller.
• There are two MAC addresses listed on the rear panel of a DMP 128 Plus AT,
one for the LAN port and one for the Dante interface. The Dante interface MAC
address is listed beneath the LAN port MAC address.
The Device View dialog populates with the selected DMP 128 Plus AT information.
Figure 178. Populated Device View Dialog Box
figure 176 Opening Device View
figure 177 Device View and Select a Dante Device Drop-Down
figure 178 Populated Device View Dialog Box
To Next Page
Loading...
