DMP 128 Plus • Dante Controller 112
6. Click the Device Config tab (see figure 179,
1
below) to open the Device Config
page.
7. In the Rename Device panel, enter the new name of the device in the text field. No
spaces are allowed in the name. Names should be significant identifiers. For example,
enter DMP128Plus-MainRack (
2
).
8. Click Apply (
3
). A confirmation prompt opens.
Figure 179. Device Config Dialog, Rename Device
9. Click Yes (
4
) to confirm the new name, then close the Device Configuration dialog
box. The new name is written to the Dante interface of the DMP 128 Plus AT. Repeat as
necessary for all devices.
NOTE: The device name assigned in Dante Controller only applies to the Dante
interface and does not affect the device name recognized in DSP Configurator.
Figure 180. Rename Device Confirmation Dialog Box
figure 179 Device Config, Rename Device
figure 180 Rename Device Confirmation Dialog Box
To Next Page
Loading...
