DMP 128 Plus • Dante Controller 120
Figure 190. Routing Tab of Network View Screen
3. To show the transmitters of a Dante device, click the + box next to the desired device in
the Dante Transmitters panel, such as AXI22D-ConfRm1 (see figure 190,
1
above).
The + changes to a – sign when the device expands.
4. To show the receivers of a Dante device, click the + box next to the desired device in
the Dante Receivers panel, such as DMP128Plus-MainRack (
2
).
5. Click the intersection of the desired subscription between a transmitter and a
receiver (
3
).
Example: The mic/line input transmitters of the AXI22D-ConfRm1 and
AXI22D-ConfRm2 are routed to the EXP input receivers of the DMP128Plus-MainRack.
A check mark at the intersection indicates the subscription is made. A check mark also
appears next to the receiver channel.
NOTE: A receiver can connect to only one transmitter. A transmitter can connect to
multiple receivers.
Disconnecting Inputs from Outputs
To undo routing, click the junction again to disconnect the receiver from the transmitter.
NOTE: After making changes to Dante network routing such as subscriptions, device
names, or channel labels, wait at least 5 seconds before disconnecting or powering
down the devices. This ensures that the new information is properly saved to those
devices. Device level configuration such as sample rates, latency, and clock settings
are saved instantly.
figure 190 Routing Tab of Network View Screen
To Next Page
Loading...
