DMP 128 Plus • Dante Controller 122
Be certain the correct LAN connection is selected (the PC LAN port that is physically
connected to the AT network) and note the IP address.
Figure 192. Configure Dante Interfaces Dialog Box
2. If it is on, turn off the PC wireless adapter. Disable all connections except the LAN
port connected to the Dante network (verify this is the correct port by checking the IP
address shown in the Configure Dante Interfaces dialog).
3. Turn off all anti-virus and firewall software on the computer.
4. Enable DHCP on the remaining network connection. This forces the computer to
acquire an IP address from the Dante interface.
NOTE: A DHCP server must be on the network for DHCP to function correctly.
Restarting Dante Controller
If subscriptions or normal operation cannot be restored, restart Dante Controller software.
To access the Dante Controller Help file, do any of the following:
• Click the Help icon in the upper-right corner of the Network View screen (see
figure 193,
1
below).
• Select Help, then Online Help or Offline Help from the menu (
2
).
• Press the <F1> key on the computer keyboard for online help or <Shift+F1> for offline
help.
Figure 193. Accessing the Dante Help File
figure 192 Configure Dante Interfaces Dialog Box
figure 193 Accessing the Dante Help File
To Next Page
Loading...
