DMP 128 Plus • Configuration Tools 76
Configuring Players
To upload an audio file:
1. Enter Live mode to connect to a DMP 128 Plus (see Live and Emulate Panel on
page18).
2. Click Tools > Configure Players.
3. From the Configure Players dialog box, click Add File to Device (see
figure 134,
2
on the previous page).
4. From the Select Audio file to load to device dialog box, locate the desired
audio file and select it (see figure 135,
1
below).
NOTE: File names containing spaces are not accepted.
5. Click Open (
2
).
Figure 135. Selecting an Audio File to Upload
6. A Loading... status bar appears in the menu status field at the top of the main
workspace. When the file is loaded successfully, the field reads File Loaded
Successfully!
Figure 136. Loading Bar and File Uploaded Successfully
7. Click OK in the Upload Complete dialog box.
Figure 137. Upload Complete Dialog Box
figure 135. Selecting an Audio File
figure 136. File Loading Bar
figure 137. Upload Complete Dialog Box
To Next Page
Loading...
