DMP 128 • Remote Control and Configuration 123
Remote
Communication and
Control
This section describes how to control the DMP 128 Plus with SIS programming and covers
the following topics:
• Connection Options
• Host-to-Device Communications
• Using the Command and Response Tables
• Command and Response Table for Basic SIS Commands
• Command and Response Table for DSP SIS Commands
• Command and Response Table for VoIP SIS Commands
• Object ID (OID) Number Tables
Connection Options
The DMP 128 Plus Digital Matrix Processor can be remotely connected via a host computer
or other device (such as a control system) attached to the rear panel RS-232 port or LAN
port, or the front panel USB Config port.
The DMP 128 Plus can be set up and controlled using SIS commands or DSP Configurator
software (see Installation on page4 for pin assignments and details on the
configuration and control port connections. For information on DSP Configurator, see DSP
Configurator Software on page10).
SIS commands can be executed using the Extron DataViewer application available from
www.extron.com. The host computer issuing the commands can be connected via the
following connections:
• RS-232 Port on the next page
• LAN Port on the next page
• USB Config Port on page125
To Next Page
Loading...
