Extron electronics DMP 128 Plus - Expansion Outputs; Naming an Expansion Output

DMP 128 Plus • DSP Configurator Software 64
Once an output has been selected, double-click the Aux output gain block again to open
the Aux Output dialog box. This dialog box functions the same as the Aux input gain block
(see Aux Input Gain Block on page44 for information on configuring the Aux Output
dialog box).
Expansion Outputs
Sixteen outputs are available in the Expansion Outputs panel. These outputs contain
DSP processing capabilities and route audio to the rear panel EXP port when another EXP
device is connected. These channels can also be transmitted to the Dante network on
DMP128Plus AT models.
Figure 113. Expansion Outputs Panel
Naming an Expansion Output
1. Click the expansion output name field.
Figure 114. Expansion Output Name Field
2. Delete the text and type the desired expansion output name.
Figure 115. New Expansion Output Name
3. Press the <Enter> key or navigate away from the field to confirm and apply the new
output name. Press the <Down Arrow> to navigate to and highlight the next name field.
Figure 116. Renamed Expansion Output
NOTE: Follow the same procedure to edit an Expansion output name.
figure 113. Expansion Outputs Panel
figure 114. Expansion Output Name Field
figure 115. New Expansion Output Name
figure 116. Renamed Expansion Output