Extron electronics DMP 128 Plus - Connect to or Disconnect from Device; Firmware Loader

DMP 128 Plus • Configuration Tools 83
To arrange devices into a folder:
1. From the Device Manager dialog box, click the New Folder button (see figure 145,
1
below).
2. Enter a name for the folder. The text for the folder name is automatically highlighted and
ready to be edited (
2
).
NOTE: Folders can be renamed later by clicking twice on the folder name and
editing the text.
3. Press <Enter>.
4. Click and drag devices over the folder name and release to insert the devices into a
folder (
3
).
Figure 145. Arranging Devices Into a Folder
Connect to or Disconnect from Device
When DSP Configurator is in Emulate mode, this selection in the Tools menu reads
Connect to Device and opens the Connect to device... dialog box when selected.
When DSPConfigurator is in Live mode and connected to a device, this selection reads
Disconnect from Device and disconnects DSP Configurator from the current device
when selected, and returns to Emulate mode.
For detailed instructions on connecting to a DMP 128 Plus see Connect to a DMP 128
Plus in Live Mode on page18. For detailed instructions on disconnecting from a
DMP128 Plus see Exit Live Mode and Enter Emulate Mode on page20.
Firmware Loader
Select Tools > Firmware Loader to open the Extron Firmware Loader software from
DSPConfigurator. Firmware Loader assists users in updating firmware or uploading new
firmware to devices via RS-232, USB, or TCP/IP connection. Refer to the Firmware Loader
Help file for more information in using the Firmware Loader software.
NOTES:
• Extron Firmware Loader software must be installed on the host PC in order for it to
be opened.
• TCP/IP connection is recommended for updating firmware.
figure 145. Arranging Devices Into a Folder