DMP 128 Plus • Dante Controller 108
Downloading and Installing Dante Controller
Dante Controller from Audinate is required to route transmitters and receivers and can be
used to configure Dante settings and monitor performance. Install Dante Controller on a PC
running Microsoft
®
Windows
®
7 or newer. For full details about computer requirements and
to download the software, see the Dante Controller product page at www.extron.com.
To download Dante Controller:
1. On the Extron Electronics Web page, click the Download tab (see figure 173,
1
below). The Download page opens.
2. On the left sidebar, click the Dante Controller link (
2
). The Dante Controller
page opens (see figure 174 on the next page).
Figure 173. Accessing the Dante Controller Download Page
figure 173 Accessing Dante Download Page
To Next Page
Loading...
