Extron electronics DMP 128 Plus - ACP 100 Configuration Example

DMP 128 Plus • Audio Control Panels 101
ACP 100 Configuration Example
1. From the DMP 128 Plus main workspace in DSP Configurator, select
Tools > Configure ACP Panels. The Configure ACPs dialog box opens.
2. Select an empty tab from the top of the dialog box to build a new configuration (see
figure 166,
1
below).
3. From the ACP Panel Type drop-down, select ACP 100 (
2
). The Configure ACPs
dialog box populates with an ACP 100 graphic.
4. From the ID # drop-down menu (
3
), select the ID number that corresponds with the
bus ID set on the ACP 100 rear panel DIP switch assembly (see the ACP 100 Setup
Guide for information on setting the bus ID).
5. In the panel graphic on the left side of the Configure ACPs dialog box, the button
labeled MIC is highlighted (yellow). When a button is highlighted, it is selected for
configuration.
6. From the Control Type drop-down, choose Selector-Vol/Mute (
4
). On the right
side of the Configure ACPs dialog box, more configuration options appear.
a. From the Volume Master drop-down (
5
), select the gain group containing all
microphone source channels. This group must be created from the Configure
Groups dialog box before it can be selected from the drop-down (see Configuring
Groups on page70).
b. From the Mute Master drop-down (
6
), select the mute group containing all
microphone source channels.
Figure 166. Starting ACP 100 Configuration
7. From the panel graphic on the left side of the dialog box, select the button labeled PRGM
(see figure 166,
7
above).
8. From the Control Type drop-down, choose Selector-Vol/Mute (
4
).
a. From the Volume Master drop-down (
5
), select the gain group containing all
program source channels.
b. From the Mute Master drop-down (
6
), select the gain group containing all
program source channels.
figure 166 Starting ACP 100