Extron electronics DMP 128 Plus - Output Processing; Output Trim Block

DMP 128 Plus • DSP Configurator Software 60
Output Processing
The output processing chain in DSP Configurator is represented by a string of blocks (see
figure 102 below). Each block contains a specific processor or type of processor. Each
output contains the following processor chain:
1. Output Trim Block
2. Output Delay Block
3. Output Filter Block
4. Output Dynamics Block
5. Output Attenuation Block
Figure 102. Output Processing Chain
Output Trim Block
Double-click the output Trim block to open the Post-mixer Trim dialog box.
Figure 103. Output Trim Block
The Post-mixer Trim dialog box provides pre-processing gain and attenuation control for
the selected output.
Figure 104. Post-mixer Trim Dialog Box
1
Output Name — This name changes to match the default or user defined output name.
2
Post-mixer Trim Fader — Click and drag the trim fader to provide up to 12 dB of gain
or 12dB of attenuation in 0.1 dB steps. Click the trim fader and use the <Up Arrow> or
<Down Arrow> to adjust the fader up or down in 0.1 dB steps.
3
Post-mixer Trim Text Box — Allows the user to enter a gain or attenuation value in
0.1 dB steps.
4
OK Button — Confirms changes made to the contained parameters and closes the
Post-mixer Trim dialog box.
5
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the Post-mixer Trim dialog box was opened
and closes the dialog box.
figure 102. Output Processing Chain
figure 103. Output Trim Block
figure 104. Post-mixer Trim Dialog Box
1
Output Name
2
Post-mixer Trim Fader
3
Post-mixer Trim Text Box
4
OK Button
5
Cancel Button