Extron electronics DMP 128 Plus - Expansion Output Processing; Expansion Output Trim Block; Expansion Output Delay Block; Expansion Output Filter Block

DMP 128 Plus • DSP Configurator Software 65
Expansion Output Processing
The expansion output processing chain in DSP Configurator is represented by a string
of blocks (see figure 117 below). Each block contains a specific processor or type of
processor. Each expansion output contains the following processor chain:
1. Expansion Output Trim Block
2. Expansion Output Delay Block
3. Expansion Output Filter Block
4. Expansion Output Dynamics Block
5. Expansion Output Attenuation Block
Figure 117. Expansion Output Processing Chain
Expansion Output Trim Block
Each expansion output contains a trim block. This block functions the same as the output
trim block (see Output Trim Block on page60 for information on configuring the
expansion output trim block).
Expansion Output Delay Block
Each expansion output contains a delay block. This block functions the same as the
mic/line input delay block (see Input Delay Block on page37 for information on
configuring the expansion output delay block).
Expansion Output Filter Block
Each expansion output contains a filter block. This block functions the same as the
mic/line input filter block, except that there are 10 slots for filters (see Input Filter Block on
page26 for information on configuring expansion output filters).
Expansion Output Dynamics Block
Each expansion output contains a dynamics block. This block functions the same as the
mic/line input dynamics blocks (see Input Dynamics Blocks on page32 for information
on configuring the expansion output dynamic filter).
Expansion Output Attenuation Block
Each expansion output contains an attenuation block. This block functions the same as the
output attenuation block (see Output Attenuation Block on page61 for information on
configuring the expansion output dynamic filter).
figure 117. Expansion Output Processing Chain