Extron electronics DMP 128 Plus - Tools

DMP 128 Plus • DSP Configurator Software 15
Tools
Figure 19. Tools Menu
1
Presets — Contains a submenu to mark and clear elements in the main workspace as
well as an option to save marked elements to a preset (see Presets on page67).
2
Configure Groups — Opens the Configure Groups dialog box to create, edit, and
delete Gain, Mute, Bass, and Treble groups (see Groups on page69).
3
Configure Digital I/O — Opens the Configure Digital I/O dialog box to assign
actions and modes to the digital inputs and outputs (see Digital I/O on page72).
4
Configure Players — Opens the Configure Players dialog box to upload audio files
and assign them to players. Player control options are also found in the dialog box (see
Players on page75).
5
Configure ACP Panels — Opens the Configure ACPs dialog box to configure Extron
Audio Control Panel interfaces (see Audio Control Panels (ACP) on page98).
6
Configure Macros — Opens the Configure Macros dialog box for creating, editing,
and deleting macro functions (see Macros on page78 for more information).
7
Connect/Disconnect from Device — When in Emulate mode, this reads Connect
to Device and opens the Connect to Device dialog box (see Connect to or
Disconnect from Device on page83). When in Live mode, this reads Disconnect
from Device and returns the software to Emulate mode.
8
Device Manager — Opens the Device Manager dialog box (see Device Manager on
page81).
9
Issue RESET Command — Clears the DMP 128 Plus of all processors and other
configuration settings. This command does not reset general settings such as IP
address.
¢
Firmware Loader — Opens the Firmware Loader application, if it is installed (see
Firmware Loader on page83). Visit www.extron.com to download the software.
£
Organize Building Blocks – Opens the Organize Building Blocks dialog box (see
Organize Building Blocks on page87).
figure 19. Tools Menu