Extron electronics DMP 128 Plus - Advanced Options

DMP 128 Plus • Web Pages 174
Line Pages
Click a Line tab to access configuration options for that line. Within each line, there are
three pages used for configuration.
Registration Page
Figure 209. VoIP Line Registration Page
To register a SIP account:
1. In the Extension field (see figure 209,
1
above), enter the extension number that
was assigned in the call server registration.
NOTE: “Line Extension” is referred to as “User ID” by some call servers.
2. In the Display Name (Optional) field (
2
), enter a display name that will appear
internally as the caller ID for the line (optional).
3. In the Password field (
3
), enter the call server registration password.
NOTE: If a password is not required by the call server, leave this field blank.
4. In the Primary Proxy Name/IP field (
4
), enter the call server IP address or domain
name.
5. In the Primary Proxy Port field (
5
), enter the SIP traffic port number.
NOTE: If a port number is not entered, 5060 is used be default.
6. Click Apply (
6
) to commit the changes to the DMP 128 Plus. Committing the changes
does not initiate line registration with the call server.
7. Click Register (
7
) to initiate registration with the call server. Registration is confirmed
in the Status field next to the Register button.
NOTE: If registration is unsuccessful, refer to the logs page (see Logs Page on
page177) and contact the VoIP system administrator.
To unregister a line from the call server, click Unregister (
8
).
Advanced Options
The Advanced ribbon (
9
) at the bottom of the page allows a secondary proxy to be
specified for redundancy purposes.
figure 209. VoIP Line Registration