Extron electronics DMP 128 Plus - Saving and Pushing ACP Configurations

DMP 128 Plus • Audio Control Panels 106
15. From the panel graphic on the left side of the dialog box, select the button labeled
PROGRAM (see figure 172,
©
below).
16. From the Control Type drop-down (
ª
), choose Selector-Vol/Mute.
a. From the Volume Master drop-down (
«
), select the gain group containing all
program source channels.
b. From the Mute Master drop-down (
¬
), select the gain group containing all
program source channels.
Figure 172. Configuring Mic and Program Selector Buttons
The ACP 106 panel is now fully configured. From this point, either:
• Add additional ACP panel configurations.
• Save the ACP panel configuration to the DSP Configurator configuration file (see Saving
and Pushing ACP Configurations below).
• Push the configurations to the DMP 128 Plus (see Saving and Pushing ACP
Configurations below).
Saving and Pushing ACP Configurations
1. Configure up to four ACP panels.
2. Close the Configure ACPs dialog box. Button configurations remain after the dialog
box is closed.
3. Save the configuration file. ACP configurations are saved with the configuration file.
4. Connect Live to a DMP 128 Plus via a LAN (TCP/IP) connection.
NOTE: The host computer must be connected to the DMP 128 Plus LAN port in
order to push ACP configurations to the device.
5. Select Tools > Configure ACP Panels. The Configure ACPs dialog box opens.
6. Click Push Configuration to Device. Configurations from all four tabs in the
Configure ACPs dialog box are pushed to the DMP 128 Plus.
figure 172 Configuring Mic and Program Selectors