DMP 128 Plus • DSP Configurator Software 20
If only pushing selected presets, mark them from the dialog box shown in figure 31
below.
Figure 31. Preset Selection Dialog Box
4. Once a push or pull is completed, the current state of the connected DMP 128 Plus
is displayed in the DSP Configurator status panel and the device is ready for further
configuration.
Exit Live Mode and Enter Emulate Mode
1. Click the Emulate button in the DSP Configurator menu bar (see figure 32,
1
).
Alternatively, select Tools > Disconnect from Device or press <F6> on the keyboard.
Figure 32. Emulate Button
2. Click OK to confirm.
Figure 33. Confirm Disconnect
figure 31. Preset Selection Dialog Box
figure 32. Emulate Button
figure 33. Confirm Disconnect
To Next Page
Loading...
