DMP 128 Plus • DSP Configurator Software 19
Figure 28. Connect to device... TCP/IP, USB, and RS-232 Dialog Box
3. When a connection with a device is established, the Synchronize with Device dialog
box opens.
Figure 29. Synchronize with Device Dialog Box
a. Pull — Pulls the configuration file, presets, macros, and ACP configurations from
the device and displays it in the DSP Configurator main workspace.
b. Push — Pushes the configuration file, presets, macros, and ACP configurations
open in DSP Configurator to the connected DMP 128 Plus. This will overwrite any
configuration currently on the device.
Click Advanced... to open the Advanced Push Options dialog box (see
figure 30).
NOTE: If only pushing selected presets, the preset selection dialog box opens
after clicking OK on the Advanced Push Options dialog box.
Figure 30. Advanced Push Options Dialog Box
figure 28. Connect to device...
figure 29. Synchronize with Device Dialog Box
figure 30. Advanced Push Options Dialog Box
To Next Page
Loading...
