Extron electronics DMP 128 Plus - Page 82

DMP 128 Plus • Configuration Tools 74
4. From the Digital Out 1 Acting upon drop-down, select an input, group, preset, or
macro affected by the mode.
Figure 133. Selecting Digital Out 1 Acting Upon
5. From the Digital Out 2 panel, select a mode for the digital output from the Mode
drop-down.
6. From the Digital Out 2 Acting upon drop-down, select the input, group, preset, or
macro affected by the mode.
7. Repeat steps 1 through 6 for additional Digital I/O configurations.
8. Click Close to close the Configure Digital I/O dialog box.
9. To save the Digital I/O configuration, click File > Save or press <Ctrl+S> and choose a
location to save the configuration file.
To push the Digital I/O configuration to a DMP 128 Plus:
1. Connect to a DMP 128 Plus in Live mode (see Live and Emulate Panel on
page18) and follow the Digital I/O configurations steps listed starting on page73.
Changes made in the Configure Digital I/O dialog box when connected Live are
applied directly to the DMP 128 Plus.
-or-
1. Follow the Digital I/O configuration steps listed starting on page73 while in Emulate
mode.
2. Connect to a DMP 128 Plus in Live mode and perform a configuration file push (see
Live and Emulate Panel on page18).
figure 133. Selecting Digital Out Acting