DMP 128 Plus • Remote Control and Configuration 134
Command ASCII command
(host to device)
Response
(device to host)
Additional description
NTP (Network Time Protocol)
Enable NTP to set the
time
E1NTEN} Nten1]
Disable NTP
E0NTEN} Nten0]
Sync NTP now
E2NTEN} Nten2]
View NTP status
ENTEN} X3!]
Set NTP IP address
EX%NTIP} NtipX%]
Clear NTP IP address
E•NTIP} Ntip]
View NTP IP address
ENTIP} X%]
Set NTP port map
ENX9#PMAP} PmapNX9#]
Reset NTP port map
EN123PMAP} PmapN00123]
Disable NTP port
EN0PMAP} PmapN00000]
View NTP port map
ENPMAP} X9#]
Port Assignment
Set telnet port map
EX9#MT} PmtX9#]
Reset telnet port map
E23MT} Pmt00023]
Disable telnet port
E0MT} Pmt00000]
View telnet port map
EMT} X9#]
Set web port map
EX9#MH} PmhX9#]
Reset web port map
E80MH} Pmh00080]
Disable web port map
E0MH} Pmh00000]
View web port map
EMH} X9#]
Set SNMP port map
EAX9#PMAP} PmapAX9#]
Reset SNMP port map
EA161PMAP} PmapA00161]
Disable SNMP port
EA0PMAP} PmapA00000]
View SNMP port map
EAPMAP} X9#]
Set SSH port map
EBX9#PMAP} PmapBX9#]
Reset SSH port map
EB22023PMAP} PmapB22023]
Disable SSH port
EB0PMAP} PmapB00000]
View SSH port map
EBPMAP} X9#]
Set SSL port map
ESX9#PMAP} PmapSX9#]
Reset SSL port map
ES443PMAP} PmapS00443]
Disable SSL port
ES0PMAP} PmapS00000]
NOTES:
X%
= IP Address xxx.xxx.xxx.xxx . Leading zeros in each of the 4 fields are op-
tional in setting values.
X3!
= NTP Status 0 = disabled (default), 1 = enabled.
X9#
= Ethernet Port Number 0 = off, custom port numbers must be 1024 or higher.
To Next Page
Loading...
