Extron electronics DMP 128 Plus - Page 154

DMP 128 Plus • Remote Control and Configuration 146
Command ASCII command
(host to device)
Response
(device to host)
Additional description
Auxiliary Input 1 through 8
Set source mode
EDX7@*X8&AU} DsDX7@*X8&]
Get source mode
EDX7@AU} X8&]
Set mute
EMX7@*X7$AU} DsMX7@*X7$]
Get mute status
EMX7@AU} X7$]
Set analog gain
EGX7@*X7#AU} DsGX7@*X7#]
Read gain
EGX7@AU} X7#]
Auxiliary Output 1 through 8
Set output mode
EDX7@*X9)AU} DsDX7@*X9)]
Get output mode
EDX7@AU} X9)]
Set mute
EMX7@*X7$AU} DsMX7@*X7$]
Get mute status
EMX7@AU} X7$]
Set attenuation
EGX7@*X7#AU} DsGX7@*X7#]
Read attenuation level
EGX7@AU} X7#]
Metering
NOTE: Metering is available on all input, pre-mixer, and output gain blocks.
Read meter level
EVX7@AU} X8**X8(]
-150.0 dBFS to 0.0 dBFS
Enable meter updates
EVX7@*X8*AU} DsVX7@*X8*]
Automixer Gate Monitoring
Get current automixer
gate status
EJX7@*X9!AU} DsJX7@*X9!]
Unsolicited automixer
gate status update
This is enabled by selecting
the Automix dialog
Monitor Gate checkbox
(see Input Automix Block
on page40).
DsVX7@*X9@*X9#]
Signal Level Monitoring (SLM)
SLM allows the user to track when the signal at a metered gain OID crosses a threshold level set by the user.
SLM is available for Input gain, Aux input gain, and Output Attenuation OIDs. When SLM is enabled for an OID,
an unsolicited message is sent when the threshold level is crossed by a rising or falling signal. The response will
include the OID, meter on/off status, and the meter level immediately after the threshold was crossed. Comparing
the set threshold and meter level in the response shows if the signal has risen above or fallen below the threshold.
Set SLM status
EJX7@*X9$AU} DsJX7@*X9$]
Get current monitor
status
EJX7@AU} DsJX7@*X9$]
Unsolicited meter value
DsVX7@*X9@*X9%]
NOTES:
• Variables not defined on this page are defined on the following page.
X7@
= Target OID See Object ID (OID) Number Tables on page150
X7#
= Gain value
dB value in 0.1 dB steps. Gain uses 10x multiplier (+10 dB = 100,
-3.4 dB = -34, and so on).
X7$
= Mute status
0 = off, 1 = engaged