DMP 128 Plus • Configuration Tools 80
8. Click Change Name at the top of the dialog box and enter a new name for the macro in
the Select Macro text field. Default macro names are Macro 1, Macro 2, and so on.
9. Up to 32 actions can be configured per macro. Follow steps 3 through 7 to configure
additional actions.
10. Connect Live to the DMP 128 Plus and click Push Macro to Device to push it to the
DMP 128 Plus. Once the macro has been pushed, it can be run via DSP Configurator, a
control system, or SIS commands.
NOTES:
• A macro cannot be run until it is pushed to the device. Edits made to an existing
macro must also be pushed to the device.
• Macro configuration data is saved on a per-line basis. When an action is completely
configured, the data is saved even if the Configure Macros dialog box is closed.
• Macro configurations are saved when the DSP Configurator configuration file is
saved.
• If DSP Configurator is closed without saving the configuration file or pushing the
macro to a DMP 128 Plus, unsaved macro configuration data is deleted.
To delete a Macro:
1. Click Tools > Configure Macros.
2. From the Select Macro drop-down, choose the macro to be deleted.
3. Once the macro information is displayed, click Delete Current Macro in the bottom
left corner of the Configure Macros dialog box.
To run a Macro:
1. Connect to the DMP 128 Plus in Live mode (see Live and Emulate Panel on
page18).
2. Click Tools > Configure Macros.
3. From the Select Macro drop-down, choose the macro to be run.
4. Once the macro information is displayed, click Run Macro.
-or-
1. Connect to the DMP 128 Plus in Live mode (see Live and Emulate Panel on
page18).
2. Select the macro to be run from the Run Macro drop-down in the tool bar.
Figure 141. Run Macro Drop-Down
To edit remote destinations:
1. Click Edit Remote Destinations from the Configure Macros dialog box.
2. Select an existing device from the Unique Device Name drop-down.
3. Edit the information for the device or click Delete to remove the selected device.
4. Click Apply to save changes made to the remote destination.
5. Click Close to close the Edit Remote Destinations dialog box.
NOTE: See step 3 on the previous page for information on adding a destination.
figure 141. Run Macro Dropdown
To Next Page
Loading...
