SMP 111 • Remote Communication and Control 87
NOTES:
X*
= On/off 0 = disabled/unassigned/off/unmuted (Default).
1 = enabled/assigned/on/muted.
X1#
= Horizontal and vertical size 00120 to 04096 (5‑digit response).
X1$
= Test patterns 0 to 8 (see page 72).
X3#
= Mute status 0 = unmuted (Default).
1 = muted.
X3%
= Overscan 0 = 0% (Default), 1 = 2.5%, 2 = 5.0%
NOTE: Horizontal shift and horizontal size values are adjusted in multiples of 8. If a value is entered that is not a multiple of 8, the
closest acceptable value is applied and returned.
NOTE: Vertical shift and vertical size values are adjusted in multiples of 2. If a value is entered that is not a multiple of 2, the
closest acceptable value is applied and returned.
Command
Function
SIS Command
(Host to Device)
Response
(Device to Host)
Additional Description
Horizontal size
Specific value E X1#
HSIZ
}
Hsiz
X1#] Set horizontal size (width) to
X1#
.
Increment value E
+ HSIZ
}
Hsiz
X1# ] Increase the width of the
window.
Decrement value E
− HSIZ
}
Hsiz
X1# ] Decrease the width of the
window.
View E
HSIZ
} X1# ] View current setting.
Vertical size
Specify a value E X1#
VSIZ
}
Vsiz
X1# ]
Set vertical size (height) to
X1#
.
Increment value E
+ VSIZ
}
Vsiz
X1#] Increase the height of the
window.
Decrement value E
− VSIZ
}
Vsiz
X1# ] Decrease the height of the
window.
View
E
VSIZ
} X1# ]
View current setting.
Video Mute
Enable blanking
1B
Vmt1
] Blanks video output.
Disable blanking
0B
Vmt0
] Displays video output.
View
B
X3# ]
View the blanking status.
Overscan mode (applies only to SMPTE [480p - 1080p] input rates)
Set overscan mode E X3%
OSCN
}
Oscn
X3%]
View overscan mode E
OSCN
} X3%]
Test Pattern
Select test pattern
E X1$
TEST
}
Test
X1$]
Turn test pattern off
E
OTEST
}
TestO
]
View test pattern E
TEST
} X1$]
HDCP Notification
Enable HDCP
notification
E
N1HDCP
}
HdcpN1
] Enable green screen (Default).
Disable HDCP
notification
E
N0HDCP
}
HdcpN0
] Disable green screen and mute
output.
View HDCP
notification
E
NHDCP
} X*]
Command and Response Tables (continued)