ST80/ST80L Flow Meter OPERATION
Fluid Components International LLC 45
ST80/ST80L Device Setup
The Device Setup function is a gateway to ST80/ST80L device
information, process data and setup, both basic and advanced.
Additional options include K Factor display/adjust and totalizer reset.
ST80/ST80L Basic Setup
The Basic Setup function includes the ability to review and
change the engineering units of the process variables, review
and change the plenum or pipe size, enable or disable the
Totalizer, review and change device information, reset the
operation of the ST80/ST80L to the factory settings, enable or
disable the write protect, and PV Setup.
Engineering Units Information
NOTE – Pressure units apply to ST100A Series only
To Next Page
Loading...
Need help?
General
