FieldServer LonWorks ProtoNode - Page 89

97 pages

Save Page as PDF

To Next Page

To Previous Page

Page 89 of 97 PN: 106417-05

Figure Appendix B-7: Grid Site Setup

Main Page

Table of Contents3
Introduction5
Lonmark Certification5
Universal Gateway Available Configurations6
Setup7
Boiler Setup7
Apex Alpine, ASPEN, Phantom-X, Raptor Boilers with Panasonic Display7
Apex, Arctic, AMP, Freeflex, BFIT, Citadel, Phantom-XL with Concert Display7
EVS and EVCA Boilers with TSBC or Burnham Commercial Models with SBC7
RWF40, LMV52, RM7800, LMV36, PD765, RWF55, LMV2_3 or YB1108
Settings for Conductor Sequencing Panel8
Protonode Setup9
Select EMS Protocol9
Enable Auto-Discovery9
Commission the Protonode for Lonworks10
Wiring11
Protonode Overview11
Wiring to the Protonode 6 Pin Connector12
Biasing the Modbus RS-485 Device Network12
End of Line Termination Switch for the Modbus RS-485 Device Network13
Thermal Solutions Boiler Control (TSBC) and Sage Boiler Control (SBC)14
Apex, Alpine, ASPEN, Phantom-X or Raptor with Panasonic Display16
Apex & Amp/Bfit/Citadel/Phantom-XL 400-1000L with Concert Display18
Older Arctic or Freeflex 1000 with Concert Display19
Arctic, AMP, Freeflex, BFIT & Citadel with Concert Display20
RWF40 or RWF5521
RM7800 Series22
ALTA, ALTAC, Phantom II, Phantom Combi II Control23
Conductor Wiring24
Protonode Lonworks Wiring24
Initial Connection to Protonode25
Record Identification Data25
Use the Protonode Web Configurator to Setup the Gateway25
Changing the Subnet of the Connected PC25
Changing the IP Address of the Protonode with Fieldserver Toolbox26
Connecting to the Protonode Web Configurator28
Ethernet Port28
Setup Web Server Security29
Login to the Fieldserver29
Select the Security Mode31
HTTPS with Own Trusted TLS Certificate32
HTTPS with Default Untrusted Self-Signed TLS Certificate or HTTP with Built-In Payload Encryption32
Setup Protonode33
Navigate to the Protonode Web Configurator33
Set Configuration Parameters34
Configure Devices Connected to the Gateway34
Verify Device Communications35
How to Start the Installation Over: Clearing Profiles35
Commissioning Lonworks Protonode36
Instructions to Upload XIF File from the Protonode LER Using FS GUI Web Server36
Setup Energy Management System Network38
Navigate to the Network Settings38
Routing Settings39
Ethernet 139
Troubleshooting41
Lost or Incorrect IP Address41
Viewing Diagnostic Information42
Checking Wiring and Settings42
LED Functions43
No Communication" Troubleshooting Trees44
General Troubleshooting44
Take Diagnostic Capture with Fieldserver Utilities45
Additional Information46
Update Firmware46
Change Web Server Security Settings after Initial Setup46
Edit the Certificate Loaded Onto the Fieldserver47
Change Fieldserver Password48
Fieldserver Manager Connection Warning Message48
System Status Button49
Protonode Information51
Specifications and Ordering Information51
Compliance with UL Regulations51
Ordering Information52
Protonode Detailed View52
Installation Details53
Universal Gateway Wiring Harness Kit (PN: 106433-02)53
Universal Gateway Enclosure Kit (PN: 112736-02)54
Lonworks Points List56
Thermal Solutions Boiler Control (TSBC) & Sage Boiler Control (SBC)56
Older Apex, Alpine/Phantom-X and Aspen/Raptor (4109 Profile)58
APEX, Amp/Bfit/Citadel/Phantom-XL, Alpine/Phantom-X, Arctic/Freeflex, Sola (4716 Profile)61
Siemens RWF4065
Siemens RWF5565
Honeywell RM780066
Siemens LMV5267
Siemens LMV3668
Precision Digital Trident PD76568
Siemens LMV2_369
Fireye YB11071
Alta/Phantom II Control73
Conductor Sequencing Panel77
Appendix A. "A" Bank DIP Switch Settings81
Appendix B. Grid Fieldserver Manager Setup84
Appendix B.1. Choose Whether to Integrate the Fieldserver Manager84
Appendix B.2. User Setup85
Appendix B.3. Registration Process87
Appendix B.4. Login to the Fieldserver Manager91
Appendix B.5. Change User Management Settings93
Appendix B.6. Create Users93
Appendix B.7. Edit Users94
Appendix B.8. Delete Users95

FieldServer LonWorks ProtoNode - Page 89

Table of Contents

Related product manuals