FIMER_PVS-175-TL A.1 Version_Product manual_EN_RevC-
F
102
Operation
General conditions
Before carry out any operation on the equipment, it is necessary to have a thorough knowledge of the
“Instruments” chapter and the functions that might have been enabled in the installation process.
The equipment operates automatically without the aid of an operator; the operating state should be
controlled through the equipment’s instrumentation.
ATTENTION – A The interpretation or variation of some data is reserved exclusively for
specialized and qualified staff.
During operation, make sure that environmental and storage conditions have not changed over time
and that the equipment is not exposed to adverse weather conditions (see “Installation” chapter).
7
To Next Page
Loading...
