Fimer PVS-175-TL - Introduction and General Information; Warranty and Supply Conditions

FIMER_PVS-175-TL A.1 Version_Product manual_EN_RevC-
F
15
Introduction and general information
Warranty and supply conditions
The warranty conditions (available on the official FIMER website) are considered to be valid if the
Customer adheres to all indications content in this manual; any condition deviating from those
described herein must be expressly agreed in the purchase order.
NOTE – D FIMER declares that the equipment complies with the provisions of law currently
in force in the country of installation and has issued the corresponding declaration of
conformity.
Not included in the supply conditions
FIMER will NOT be held liable for defects or malfunctions arising from:
• improper use of the equipment;
• deterioration resulting from transportation or particular environmental conditions;
• performing maintenance incorrectly or not at all;
• tampering or unsafe repairs;
• use or installation by unqualified persons.
FIMER is not responsible for disposal of the equipment, or part of it, which does not take place on the
basis of the regulations and laws in force in the country of installation.
ATTENTION – A FIMER accepts no liability for failure to comply with the instructions for a
correct installation and will not be held responsible for systems upstream or downstream of
the equipment it has supplied.
FORBIDDEN – H It is absolutely forbidden to modify the equipment. Any modification,
manipulation, or alteration not expressly agreed with the manufacturer, concerning either
hardware or software, shall result in the immediate cancellation of the warranty.
NOTE – D The customer is fully responsible for any changes made to the system.
2